Шаблоны для сайтов в системе uCoz
Main » Articles » B.U.D.S. (BRP Utility and Diagnostic Software) User Manual

Entries in category: 7
Shown entries: 1-7
Pages:

Distribution.

Disclaimer.

B.U.D.S. (BRP Utility and Diagnostic Software) User Manual | Views: 1975 | Added by: Admin2 | Date: 14.08.2012

B.U.D.S. communicates with the electronic blocks of the vehicle through the MPI ® (Multi Protocol Interface).

Today, there are two models of MPI adapters: MPI-1 and MPI-2 (or MPI-II).

B.U.D.S. (BRP Utility and Diagnostic Software) User Manual | Views: 4862 | Added by: Admin2 | Date: 14.08.2012

B.U.D.S. Program Installation
B.U.D.S. (BRP Utility and Diagnostic Software) User Manual | Views: 2717 | Added by: Admin2 | Date: 14.08.2012

How to launch B.U.D.S. in demo mode.
B.U.D.S. (BRP Utility and Diagnostic Software) User Manual | Views: 2166 | Added by: Admin2 | Date: 14.08.2012

The MPI-2 BUDS license key is valid for installation into the program within 24 hours only!

If this condition is met, then use Method 1 (normal).

B.U.D.S. (BRP Utility and Diagnostic Software) User Manual | Views: 4359 | Added by: Admin2 | Date: 14.08.2012

If you have not installed a license key within the specified period (24 hours), and the program displays a message that the license key has expired, we are recommend to use Method 2 (file "License.dat").

These instructions will be useful in such cases:

 1. License key did not installed within 24 hours and the program reports that the license has expired.

 2. You have installed a new version of B.U.D.S. and is necessary to transfer your license to new program.

 3. You want to transfer your license key to another computer (buying a new laptop, sale of diagnostic equipment).

 4. Falling of Windows operating system on your computer or any other reason related to the performance of your computer.        

 5. Other cases in which it is impossible to install a license key by Method 1 (normal).

B.U.D.S. (BRP Utility and Diagnostic Software) User Manual | Views: 3754 | Added by: Admin2 | Date: 14.08.2012

The Digitally Encoded Security System (DESS) features an anti-start protection against unauthorized use of the watercraft.
The following components are specially designed for this system: Multi-Purpose Electronic Module (MPEM), safety lanyard cap and safety lanyard switch.
The safety lanyard cap has a magnet and a ROM chip. The chip has a unique digital code.
The DESS circuitry in the watercraft MPEM is activated at the factory. Therefore, a safety lanyard must be programmed to start the engine.
NOTE:
Actually, it is the memory of the MPEM which is programmed to recognize the digital code of the safety lanyard cap.
The system is quite flexible. Up to eight safety lanyards may be programmed in the memory of the watercraft MPEM. They can also be erased.
NOTE: If desired, a safety lanyard can be used on other watercraft equipped with the DESS.
The memory of the MPEM is permanent. If the battery is disconnected, no information is lost.
When ordering a new MPEM from the regular parts channel, the DESS circuitry will be activated.
The MPEM features a self-diagnostic mode. Refer
to the chart following.
B.U.D.S. (BRP Utility and Diagnostic Software) User Manual | Views: 4537 | Added by: Admin2 | Date: 14.08.2012